DTC B1785: Front Occupant Classification Sensor LH Collision Detection: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Using the Techstream, perform Zero Point Calibration. Refer to INITIALIZATION .

   OK

   "Zero Point Calibration is complete." is displayed.

NG → See step   4 

OK: Go to next step 

1. Turn the power switch on (IG).
2. Clear the DTCs stored in the occupant detection ECU. Refer to DTC CHECK / CLEAR .
3. Clear the DTCs stored in the airbag sensor assembly. Refer to DTC CHECK / CLEAR .
4. Turn the power switch off.
5. Turn the power switch on (IG).
6. Check for DTCs. Refer to DTC CHECK / CLEAR .

   OK

   DTC B1785 is not output.

   HINT: 

   Codes other than DTC B1785 may be output at this time, but they are not related to this check.

NG → See step   4 

OK: Go to next step 

1. Using the Techstream, perform Sensitivity Check. Refer to INITIALIZATION .

NEXT → END 

1. Turn the power switch off.
2. Disconnect the cable from the negative (-) auxiliary battery terminal.
3. Replace the front seat cushion spring assembly. Refer to DISASSEMBLY for Manual seat. Refer to DISASSEMBLY for Power seat).

NEXT: Go to next step 

1. Connect the cable to the negative (-) auxiliary battery terminal.
2. Turn the power switch on (IG).
3. Using the Techstream, perform Zero Point Calibration. Refer to INITIALIZATION .

NEXT: Go to next step 

1. Using the Techstream, perform Sensitivity Check. Refer to INITIALIZATION .

NEXT → END