DTC P060A: Internal Control Module Monitoring Processor Performance: Procedure

1. Connect Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Refer to DTC CHECK / CLEAR and clear DTC.
5. Turn the engine switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.
8. Connect the cable to the battery negative (-) terminal.
9. Connect the Techstream to the DLC3.
10. Turn the engine switch on (IG).
11. Wait 16 seconds or more.
12. Turn the Techstream on.
13. Enter the following menus: Powertrain / Engine / Trouble Codes.
14. Read DTCs.

    Result

    Result	Proceed to
    No output	A
    P060A	B

B → Go to step   3 

A → Go to step   2