DTC P0106: Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG) and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
4. Read the DTCs.
   RESULT
   
   

   Result	Proceed to
   DTC P0106 is output	A
   DTC P0106 and other DTCs are output	B

   HINT: 

   If any DTCs other than P0106 are output, troubleshoot those DTCs first.

B → See step   6 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Put the engine in inspection mode. Refer to INSPECTION MODE PROCEDURE .
3. Turn the Techstream on.
4. Start the engine and warm it up.
5. Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.
6. Read the MAP value at engine idling.

   Standard

   Engine Condition	Techstream Display
   Power switch on (IG)	80 to 110 kPa-a (600 to 825 mmHg-a)
   Idling	20 to 40 kPa-a (150 to 300 mmHg-a)

NG → See step   3 

OK → See step   4 

1. Check the intake system for vacuum leaks. Refer to ON-VEHICLE INSPECTION - Step 1 .

   OK

   No leaks in the intake system.

NG → REPAIR OR REPLACE INTAKE SYSTEM 

OK → See step   5