DTC U0100: Communication Stop from ECM to Distance Control ECU, VSC; DTC U0122: Lost Communication with Vehicle Dynamics Control Module; DTC U0123: Lost Communication with Yaw Rate Sensor Module; DTC U0126: Lost Communication with Steering Angle Sensor Module; DTC U1101: Lost Communication with Distance Control ECU (08/2011 - ): Procedure
- CHECK DTC (CAN COMMUNICATION SYSTEM)
- Use the Techstream to check if the CAN communication system is functioning normally. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
.
OK
DTC is not output.
NG → See step 3
OK → See step 2
- Use the Techstream to check if the CAN communication system is functioning normally. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
.
- USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING
- GO TO CAN COMMUNICATION SYSTEM. Refer to DIAGNOSIS SYSTEM