Removal

SEAT: POWER SEAT CONTROL ECU (for Rear No. 2 Seat): REMOVAL

NOTICE:
* If the fold seat control ECU is replaced with a new one, perform initialization (initial position memorization) of the fold seat control ECU Rear Power Seat Control System.
* If the fold seat control ECU is exchanged with one from another vehicle, perform initialization (initial position reset and initial position memorization) of the fold seat control ECU Rear Power Seat Control System.

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. REMOVE DECK BOARD ASSEMBLY Removal

2. REMOVE FOLD SEAT CONTROL ECU

(a) Using a clip remover, remove the 3 clips.

(b) Disconnect the 2 connectors.