Sound Signal Circuit between Navigation ECU and Multi-media Interface ECU: Procedure

1. Disconnect the display and navigation module display connector and multi-media interface ECU connector.
   Fig 1: J63 And J99 Connector Terminal Identification

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Measure the resistance according to the value(s) in the table below.
   STANDARD RESISTANCE
   
   

   Tester Connection	Condition	Specified Condition
   J63-1 (AGND) - J99-1 (USD1)	Always	Below 1 Ω
   J63-3 (VAR+) - J99-2 (URO+)	Always	Below 1 Ω
   J63-4 (VAL+) - J99-3 (ULO+)	Always	Below 1 Ω
   J63-7 (VA-) - J99-4 (UGD1)	Always	Below 1 Ω
   J63-1 (AGND) - Body ground	Always	10 kΩ or higher
   J63-3 (VAR+) - Body ground	Always	10 kΩ or higher
   J63-4 (VAL+) - Body ground	Always	10 kΩ or higher
   J63-7 (VA-) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Display and Navigation Module Display)
   *2	Front view of wire harness connector (to Multi-media Interface ECU)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   2