DTC B1796: Sleep Operation Failure of Occupant Classification ECU: Procedure

1. Turn the power switch off.
2. Disconnect the cable from the negative (-) auxiliary battery terminal.
3. Replace the occupant detection ECU. Refer to REMOVAL [08/2012 - ] .

NEXT: Go to next step 

1. Connect the cable to the negative (-) auxiliary battery terminal.
2. Turn the power switch on (IG).
3. Using the Techstream, perform Zero Point Calibration. Refer to INITIALIZATION [08/2012 - ] .

NEXT: Go to next step 

1. Using the Techstream, perform Sensitivity Check. Refer to INITIALIZATION [08/2012 - ] .

NEXT → END