DTC C1AA8: Front Camera Module Incorrect Axial Gap; DTC C1AA9: Front Camera Module Beam Axis Not Adjusted: Procedure

Refer to ADJUSTMENT [06/2012 - ]

NEXT: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.
4. Clear DTCs.
5. Turn the engine switch off.

NEXT: Go to next step 

1. Perform the following to make sure the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG).
4. Enter the following menus: Chassis / Lane Departure Alert / Trouble Codes.
5. Check for DTCs.

   OK

   DTC C1AA8 or C1AA9 is not output.

6. Turn the engine switch off.

NG → See step   4 

OK → END