LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2013 >> IS 350 Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Can Communication System (Diagnostics & Symptom Tests) >> Can Communication System >> Symptom Tests >> Multi-media Module Receiver Assembly Communication Stop Mode >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

NOTE:
  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2012 - ] .
  • After performing repairs, perform the procedure listed in DTC Reproduction Method and confirm that the DTCs are not output again.
  • DTC Reproduction Method: Turn the engine switch on (IG) and wait at least 60 seconds.
  • After the repair, perform CAN Bus Check and check that all the ECUs and sensors connected to the CAN communication system are displayed. Refer to DIAGNOSIS SYSTEM [08/2012 - ] .
scientia non olet · About LEMON Manuals