Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter (03/2012 - 07/2012): Procedure

1. Check the output waveform.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the combination meter assembly with the connector still connected.
   2. Connect an oscilloscope to terminal F15-3 (+S) and body ground.
   3. Turn the engine switch on (IG).
   4. Turn a wheel slowly.
   5. Check the signal waveform according to the condition(s) in the table below.

      Item	Condition
      Measurement terminal	F15-3 (+S) - Body ground
      Tool setting	5 V/DIV., 20 ms./DIV.
      Vehicle condition	Wheel being rotated

      OK

      The waveform is similar to that shown in the illustration.

      HINT: 

      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

      TEXT IN ILLUSTRATION
      
      

      *a	Component with harness connected (Combination Meter Assembly)

NG → See step   5 

OK: Go to next step 

1. Check the input waveform.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the radio receiver assembly with the connector(s) still connected.
   2. Connect an oscilloscope to terminal G9-3 (SPD) and body ground.
   3. Turn the engine switch on (IG).
   4. Turn a wheel slowly.
   5. Check the signal waveform according to the condition(s) in the table below.

      Item	Condition
      Measurement terminal	G9-3 (SPD) - Body ground
      Tool setting	5 V/DIV., 20 ms./DIV.
      Vehicle condition	Wheel being rotated

      OK

      The waveform is similar to that shown in the illustration.

      HINT: 

      When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.

      TEXT IN ILLUSTRATION
      
      

      *a	Component with harness connected (Radio Receiver Assembly)

NG → See step   3 

OK → See step   4 

1. Disconnect the G9 radio receiver assembly connector.
2. Disconnect the F93 junction connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G9-3 (SPD) - F93-47	Always	Below 1 Ω

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR (RADIO RECEIVER ASSEMBLY - JUNCTION CONNECTOR) 

OK → REPAIR OR REPLACE HARNESS OR CONNECTOR (JUNCTION CONNECTOR)