How To Proceed With Troubleshooting [03/2012 - 07/2012]

HINT: 

*: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. CUSTOMER PROBLEM ANALYSIS 
   1. Interview the customer and confirm the problem. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2012 - 07/2012] .

      HINT: 

      Interview the customer to confirm the following:

      • History of brake fluid replacement.
      • Whether the engine was stopped intentionally when driving.
      • Whether the brake and accelerator pedals were depressed simultaneously.

      NEXT: Go to next step 

3. CHECK DTC AND FREEZE FRAME DATA* 
   1. Check and record DTCs and Freeze Frame Data.
   2. Clear the DTCs and Freeze Frame Data. Refer to DTC CHECK / CLEAR [03/2012 - ]  for DTC Check/Clear, or. Refer to FREEZE FRAME DATA [03/2012 - ]  for Freeze Frame Data).
   3. Reconfirm the DTCs.
      1. Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data. Refer to DTC CHECK / CLEAR [03/2012 - ]  for DTC Check/Clear, or. Refer to FREEZE FRAME DATA [03/2012 - ]  for Freeze Frame Data).

         HINT: 

         • When DTCs indicating CAN communication system malfunctions are output, repair the CAN communication system before repairing each corresponding sensor. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2012 - 07/2012] .
         • If any of DTCs U0100, U0123, U0124, and U0126 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit. Refer to CHECK FOR INTERMITTENT PROBLEMS [03/2012 - ] .

         Result

         Result	Proceed to
         DTC is output	A
         DTC is not output (Problem symptom does not occur)	B
         DTC is not output (Problem symptom occurs)	C

      B → GO TO STEP 5 

      C → GO TO STEP 6 

      A: Go to next step 

4. DIAGNOSTIC TROUBLE CODE CHART 
   1. Proceed to Diagnostic Trouble Code Chart. Refer to DIAGNOSTIC TROUBLE CODE CHART [03/2012 - ] .

      NEXT → GO TO STEP 7 

5. SYMPTOM SIMULATION 
   1. Proceed to How to Proceed with Troubleshooting. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2012 - 07/2012] .

      NEXT: Go to next step 

6. PROBLEM SYMPTOMS TABLE 
   1. Proceed to Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE [03/2012 - 07/2012] .

      NEXT: Go to next step 

7. CIRCUIT INSPECTION* 

   NEXT: Go to next step 

8. IDENTIFICATION OF PROBLEM 

   NEXT: Go to next step 

9. REPAIR OR REPLACEMENT 

   NEXT: Go to next step 

10. CONFIRMATION TEST* 

    NEXT → END