Stereo Component Amplifier Communication Error: Procedure

1. Enter diagnostic mode. Refer to DTC CHECK / CLEAR [03/2012 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Press preset switch "2" to change the mode to "Detailed Information Mode".
3. Identify the component shown by the sub-code.

   HINT: 

   • The sub-code "P190" shown in above example indicates the radio receiver assembly.
   • For details of the DTC display, refer to DTC Check/Clear. Refer to DTC CHECK / CLEAR [03/2012 - ] .

NEXT: Go to next step 

1. Inspect the power source circuit of the component shown by the sub-code.

   If the power source circuit is operating normally, proceed to the next step.

   HINT: 

   The satellite radio tuner is built into the radio receiver assembly. If there is a problem between the satellite radio tuner and radio receiver assembly, replace the radio receiver assembly.

   COMPONENT TABLE
   
   

   Component	Proceed to
   Radio receiver assembly (190)	Radio receiver power source circuit. Refer to Radio Receiver Power Source Circuit
   Satellite radio tuner (1F1)	Radio receiver power source circuit. Refer to Radio Receiver Power Source Circuit
   Accessory meter assembly (1D4)	Accessory meter does not illuminate. Refer to Accessory Meter does not Illuminate
   Air conditioning control panel (1C4)	Air conditioning control panel circuit. Refer to Air Conditioning Control Panel Circuit

NEXT: Go to next step 

1. Disconnect the G7, G11 and G9 radio receiver assembly connectors.
2. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G7-5 (ATX+) - G7-15 (ATX-)	Always	60 to 80 Ω
   G11-9 (TXM+) - G11-10 (TXM-)	Always	60 to 80 Ω
   G9-9 (TX+) - G9-10 (TX-)	Always	60 to 80 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Component without harness connected (Radio Receiver Assembly)

NG → See step   6 

OK: Go to next step 

HINT: 

• Start the check from the circuit that is near the component shown by the sub-code first.
• For details of the connectors, refer to Terminals of ECU. Refer to TERMINALS OF ECU [03/2012 - ] .

1. Referring to the following AVC-LAN wiring diagram, check the AVC-LAN circuit between the stereo component amplifier assembly and the component shown by the sub-code.
   1. Disconnect all connectors between the stereo component amplifier assembly and component shown by the sub-code.
   2. Check for an open or short in the AVC-LAN circuit between the stereo component amplifier assembly and component shown by the sub-code.

      OK

      There is no open or short circuit.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the component shown by the sub-code with a known good one and check if the same problem occurs again.

   OK

   Malfunction disappears.

NG → See step   7 

OK → END