DTC P0116: Engine Coolant Temperature Circuit Range / Performance Problem [09/2013 - ]: Procedure
- CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO DTC P0116)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Result
Result Proceed to DTC P0116 is output A DTC P0116 and other DTCs are output B HINT:
If any DTCs other than P0116 are output, troubleshoot those DTCs first.
B → See step 4
A: Go to next step
- INSPECT WATER INLET WITH THERMOSTAT
- Inspect the water inlet with thermostat. Refer to INSPECTION [09/2013 - ]
.
HINT:
Perform "Inspection After Repair" after replacing the engine coolant temperature sensor. Refer to INITIALIZATION [09/2013 - ] .
NG → See step 5
OK → See step 3
- Inspect the water inlet with thermostat. Refer to INSPECTION [09/2013 - ]
.
- REPLACE ENGINE COOLANT TEMPERATURE SENSOR. Refer to REMOVAL [09/2013 - ]
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2013 - ]
- REPLACE WATER INLET WITH THERMOSTAT. Refer to REMOVAL [09/2013 - ]