Display Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter [08/2013 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
- Disconnect the H12 multi-media module receiver assembly connector.
- Disconnect the H30 No. 1 stereo jack adapter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition H12-6 (VV+) - H30-8 (VV+) Always Below 1 Ω H12-14 (VV-) - H30-9 (VV-) Always Below 1 Ω H12-6 (VV+) - Body ground Always 10 kΩ or higher H12-14 (VV-) - Body ground Always 10 kΩ or higher H12-13 (SG) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]