Washer Fluid Level Warning Switch Circuit [08/2013 - ]: Procedure

1. Use the Data List to check if the level warning switch assembly is functioning properly. Refer to DATA LIST / ACTIVE TEST [08/2013 - ] .
   COMBINATION METER
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Washer Switch	Level warning switch assembly signal / ON or OFF	ON: Fluid volume is less than 550 to 750 cc (33.5 to 45.7 cu.in.) OFF: Fluid volume is more than 550 to 750 cc (33.5 to 45.7 cu.in.)	-

   OK

   On Techstream screen, item changes between ON and OFF according to above chart.

NG → See step   2 

OK → See step   5 

1. Remove the level warning switch assembly. Refer to REMOVAL [08/2013 - ] .
2. Inspect the level warning switch assembly. Refer to INSPECTION [08/2013 - ]

NG → See step   6 

OK: Go to next step 

1. Disconnect the A20 and B washer wiring assembly connectors.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A20-3 (S) - B-1	Always	Below 1 Ω
   A20-6 (E) - B-2	Always	Below 1 Ω
   A20-3 (S) or B-1 - Body ground	Always	10 kΩ or higher
   A20-6 (E) or B-2 - Body ground	Always	10 kΩ or higher

NG → REPLACE WASHER WIRING ASSEMBLY 

OK: Go to next step 

1. Disconnect the A20 washer wiring assembly connector.
2. Disconnect the G3 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A20-3 (S) - G3-34 (WLVL)	Always	Below 1 Ω
   A20-6 (E) - Body ground	Always	Below 1 Ω
   A20-3 (S) or G3-34 (WLVL) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   7