How To Proceed With Troubleshooting [09/2013 - ]

HINT: 

• Use the following procedure to troubleshoot the rear view monitor system.
• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 
   1. Measure the battery voltage with the engine switch off.

      Standard voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding.

      NEXT: Go to next step 

3. CUSTOMER PROBLEM ANALYSIS 

   NEXT: Go to next step 

4. CHECK NAVIGATION SYSTEM 
   1. Refer to the navigation system. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2013 - ] .
      RESULT
      
      

      Result	Proceed to
      Navigation system is normal	A
      Navigation system is abnormal	B

      B → Go to NAVIGATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2013 - ] 

      A: Go to next step 

5. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2013 - ] .
      RESULT
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

      B → Go to CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [09/2013 - ] 

      A: Go to next step 

6. CHECK FOR DTC* 
   1. Check for DTCs. Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2013 - ] .
      RESULT
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

      B → Go to DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [09/2013 - ]  

      A: Go to next step 

7. PROBLEM SYMPTOMS TABLE 
   1. Refer to the Problem Symptoms Table. Refer to PROBLEM SYMPTOMS TABLE [09/2013 - ] .
      RESULT
      
      

      Result	Proceed to
      Fault is not listed in Problem Symptoms Table	A
      Fault is listed in Problem Symptoms Table	B

      B → ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

      A: Go to next step 

8. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Terminals of ECU. Refer to TERMINALS OF ECU [09/2013 - ] 

      NEXT: Go to next step 

9. ADJUST, REPAIR OR REPLACE 

   NEXT: Go to next step 

10. CONFIRMATION TEST 

    NEXT → END