Back Door Entry Unlock Function does not Operate [08/2013 - ]: Procedure

1. When the door control switch of the master switch assembly is operated, check that the locked doors unlock.

   OK

   Door locks operate normally.

NG → See step   6 

OK: Go to next step 

1. When the power back door switch is operated, check that the power back door opens.

   OK

   Power back door is open.

NG → See step   8 

OK: Go to next step 

1. Using the Techstream, read the Data List.
   MAIN BODY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Back Door Handle SW	Back door opener switch / ON or OFF	ON: Back door opener switch pushed OFF: Back door opener switch not pushed	-

   OK

   "ON" (switch is pushed) and "OFF" (switch is not pushed) appears on the screen.

NG → See step   4 

OK → REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) 

1. Remove the back door opener switch. Refer to REMOVAL [08/2013 - ] .

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   1 (UL) - 2 (L) 3 (B) - 2 (L)	Not pushed	10 kΩ or higher
   1 (UL) - 2 (L)	Lock switch pushed	Below 1 Ω
   3 (B) - 2 (L)	Open switch pushed	Below 1 Ω

NG → See step   7 

OK: Go to next step 

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the E1 ECU connector.
2. Disconnect the S7 switch connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E1-26 (BDSU) - S7-3 (B)	Always	Below 1 Ω
   E1-26 (BDSU) or S7-3 (B) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)