DTC C1AA9: Front Camera Module Beam Axis Not Adjusted [10/2015 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

2. Perform the following procedure.

   HINT: 

   If the following procedure is not performed, the previously output DTC cannot be detected.

   1. Turn the engine switch on (IG) and wait 2 seconds or more.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   Result

   Result	Proceed to
   DTC C1AA9 is output	A
   DTC C1AA9 is not output	B

Result: 

B 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] 

Result: 

A 

See step  2

1. Adjust the forward recognition camera.

   Refer to ADJUSTMENT [10/2015 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Make sure that the following conditions are met.

   HINT: 

   If the conditions are not met, the system cannot detect the malfunction.

   1. Turn the engine switch on (IG) and wait 2 seconds or more.
2. Check for DTCs.

   Refer to DTC CHECK / CLEAR [10/2015 - ]

   Result

   Result	Proceed to
   DTC C1AA9 is not output	A
   DTC C1AA9 is output	B

Result: 

A 

END 

Result: 

B 

REPLACE FORWARD RECOGNITION CAMERA. Refer to  REMOVAL [10/2015 - ]