Display Signal Circuit between Multi-display and Radio Receiver [09/2014 - 10/2015]: Procedure

1. Check if the digital communication cable connectors between the multi-media module receiver assembly and the accessory meter assembly*1 or multi-display*2 have any connection problems (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 10/2015] ).
   1. *1: for 12.3 Inch
   2. *2: for 8 Inch
2. Check that the screen display is normal.

   OK

   Screen display is normal.

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - 10/2015] )

Result: 

NG 

See step  2

1. Replace the accessory meter assembly*1 or multi-display*2 (Refer to REMOVAL [09/2014 - ] ).
   1. *1: for 12.3 Inch
   2. *2: for 8 Inch
2. Check that the screen display is normal.

   OK

   Screen display is normal.

Result: 

OK 

END (ACCESSORY METER ASSEMBLY OR MULTI-DISPLAY IS DEFECTIVE) 

Result: 

NG 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [09/2014 - ] )