DTC C1AC2: Slave Module Horizontal Axis Misalignment [08/2013 - ]: Procedure

CHECK INSTALLATION CONDITION
1. Check the installation condition of the blind spot monitor sensor RH. Refer to OPERATION CHECK [08/2013 - ] .
  HINT:
  
  Take the appropriate action in accordance with the result.
NEXT: Go to next step
PERFORM BEAM AXIS CONFIRMATION
1. Install the rear bumper. Refer to INSTALLATION [08/2013 - ] .
2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream. Refer to OPERATION CHECK [08/2013 - ] .
NG → See step 3

OK → END
REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to REMOVAL [08/2013 - ]