Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter [08/2013 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
- Disconnect the H16 multi-media module receiver assembly connector.
- Disconnect the H31 No. 1 stereo jack adapter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition H16-2 (US1-) - H31-2 (UDO-) Always Below 1 Ω H16-3 (US1+) - H31-3 (UDO+) Always Below 1 Ω H16-2 (US1-) - Body ground Always 10 kΩ or higher H16-3 (US1+) - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [08/2013 - ]