DTC C1AC1: Master Module Horizontal Axis Misalignment [10/2014 - ]: Procedure
- CHECK INSTALLATION CONDITION
- Check the installation condition of the blind spot monitor sensor LH. Refer to OPERATION CHECK [10/2014 - ]
.
HINT:
Take the appropriate action in accordance with the result.
NEXT: Go to next step
- Check the installation condition of the blind spot monitor sensor LH. Refer to OPERATION CHECK [10/2014 - ]
.
- PERFORM BEAM AXIS CONFIRMATION
- Install the rear bumper. Refer to INSTALLATION [10/2014 - ] .
- Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream. Refer to OPERATION CHECK [10/2014 - ] .
NG → See step 3
OK → END
- REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to REMOVAL [10/2014 - ]