DTC P062F: Internal Control Module EEPROM Error [10/2014 - ]: Procedure
- CHECK DTC OUTPUT (IN ADDITION DTC P062F)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Clear DTCs. Refer to DTC CHECK / CLEAR [10/2014 - ] .
- Turn the engine switch off and turn the Techstream off.
- Disconnect the Techstream.
- Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
- Connect the cable to the negative (-) battery terminal.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / ECT / Trouble Codes.
- Read the DTCs using the Techstream.
Result
Display (DTC output) Proceed to P062F is output A No DTC B
B → See step 3
A: Go to next step
- REPLACE TCM
- Replace the TCM. Refer to REMOVAL [10/2014 - ] .
NEXT → See step 4
- CHECK FOR INTERMITTENT PROBLEMS. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ]
- PERFORM A/T CODE REGISTRATION. Refer to REGISTRATION [10/2014 - ]