IG Power Source Circuit [03/2014 - ]: Procedure

1. Disconnect the F36 multiplex tilt and telescopic ECU connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   F36-8 (IG) - Body ground	Engine switch on (IG)	11 to 14 V

   TEXT IN ILLUSTRATION
   
   

   *1	Rear view of wire harness connector (to Multiplex Tilt and Telescopic ECU)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   F36-11 (GND) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *1	Rear view of wire harness connector (to Multiplex Tilt and Telescopic ECU)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   3