DTC C1AC1: Master Module Horizontal Axis Misalignment [10/2015 - 09/2016]: Procedure

1. Check the installation condition of the blind spot monitor sensor RH (Refer to REMOVAL [09/2014 - ] ).

   HINT: 

   Take the appropriate action in accordance with the result.

Result: 

NEXT 

See step  2

1. Install the rear bumper (Refer to INSTALLATION [09/2014 - ] ).
2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (Refer to OPERATION CHECK [10/2015 - 09/2016] ).

Result: 

OK 

END 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR RH 

(Refer to REMOVAL [09/2014 - ] )