DTC C1AC1: Master Module Horizontal Axis Misalignment [09/2014 - 10/2015]: Procedure

1. Check the installation condition of the blind spot monitor sensor RH (See page. Refer to INSTALLATION [09/2014 - ] ).

   HINT: 

   Take the appropriate action in accordance with the result.

Result:  NEXT

NEXT 

See step  2

1. Install the rear bumper (See page. Refer to REMOVAL [09/2014 - 09/2016] ).
2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (See page. Refer to OPERATION CHECK [09/2014 - 10/2015] ).

Result:  OK

OK 

END 

Result:  NG

NG 

REPLACE BLIND SPOT MONITOR SENSOR RH 

(See page. Refer to REMOVAL [09/2014 - ] )