DTC B1575: GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) [08/2015 - 08/2021]: Procedure

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - 08/2020] , or refer to DTC CHECK / CLEAR [08/2020 - 08/2021] ).

Result: 

NEXT 

See step  2

1. Recheck for DTCs and check if the same DTC is output again (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - 08/2020] , or refer to DTC CHECK / CLEAR [08/2020 - 08/2021] ).

   OK

   No DTCs are output.

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - 08/2020] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2020 - 08/2021] )

Result: 

NG 

See step  3

1. Replace the harness and connector (GVIF cable) with a new or normally functioning one.

Result: 

NEXT 

See step  4

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - 08/2020] , or refer to DTC CHECK / CLEAR [08/2020 - 08/2021] ).

Result: 

NEXT 

See step  5

1. Recheck for DTCs and check if the same DTC is output again (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] , or refer to DTC CHECK / CLEAR [08/2019 - 08/2020] , or refer to DTC CHECK / CLEAR [08/2020 - 08/2021] ).

   OK

   No DTCs are output.

Result: 

OK 

END (GVIF CABLE IS DEFECTIVE) 

Result: 

NG 

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY 

(Refer to REMOVAL [08/2015 - 08/2021] )