DTC C1AC1: Master Module Horizontal Axis Misalignment [08/2016 - ]: Procedure

1. Check the installation condition of the blind spot monitor sensor LH (Refer to OPERATION CHECK [08/2016 - 08/2020] , or refer to OPERATION CHECK [08/2020 - 08/2021] , or refer to OPERATION CHECK [08/2021 - ] ).

   HINT: 

   Take the appropriate action in accordance with the result.

Result: 

NEXT 

See step  2

1. Install the rear bumper (Refer to INSTALLATION [08/2015 - 08/2019] , or refer to INSTALLATION [08/2019 - ] ).
2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream (Refer to OPERATION CHECK [08/2016 - 08/2020] , or refer to OPERATION CHECK [08/2020 - 08/2021] , or refer to OPERATION CHECK [08/2021 - ] ).

Result: 

OK 

END 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR LH 

(Refer to REMOVAL [08/2015 - 08/2020] , or refer to REMOVAL [08/2020 - ] )