Installation [08/2015 - 08/2019]: Procedure

INSTALL DRIVING SUPPORT SWITCH CONTROL ECU
1. Install the driving support switch control ECU with the bolt.
  Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf)
2. Connect the connector.
INSTALL INSTRUMENT PANEL BOX ASSEMBLY
Refer to PROCEDURE - Step 16
INSTALL INSTRUMENT PANEL BOX DOOR COVER
Refer to PROCEDURE - Step 17
INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 20
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH
Refer to PROCEDURE - Step 21
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 22
INSTALL NO. 2 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL INSTRUMENT LOWER COVER LH
Refer to PROCEDURE - Step 19
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 11
INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Refer to PROCEDURE - Step 8
INSTALL COWL SIDE TRIM BOARD RH
Refer to PROCEDURE - Step 12
INSTALL DOOR SCUFF PLATE ASSEMBLY RH
Refer to PROCEDURE - Step 13
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (Refer to SYSTEM DESCRIPTION [08/2015 - ] ).