DCM Data Signal Circuit between Navigation ECU and DCM [09/2015 - 08/2017]: Procedure

1. Disconnect the DCM (telematics transceiver) connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Disconnect the multi-media module receiver assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   P7-1-1 (USB-) - F103-1-1 (USB-)	Always	Below 1 Ω
   P7-1-2 (USB+) - F103-1-2 (USB+)	Always	Below 1 Ω
   P7-1-3 (USBS) - F103-1-3 (USBS)	Always	Below 1 Ω
   P7-2 (USBG) - F103-2 (USBG)	Always	Below 1 Ω
   P7-3 (VOT+) - F103-7 (VOR+)	Always	Below 1 Ω
   P7-4 (USBV) - F103-4 (USBV)	Always	Below 1 Ω
   P7-5 (VOT-) - F103-6 (VOR-)	Always	Below 1 Ω
   P7-6 (VOR-) - F103-5 (VOT-)	Always	Below 1 Ω
   P7-7 (VOR+) - F103-3 (VOT+)	Always	Below 1 Ω
   P7-1-1 (USB-) - Body ground	Always	10 kΩ or higher
   P7-1-2 (USB+) - Body ground	Always	10 kΩ or higher
   P7-1-3 (USBS) - Body ground	Always	10 kΩ or higher
   P7-2 (USBG) - Body ground	Always	10 kΩ or higher
   P7-3 (VOT+) - Body ground	Always	10 kΩ or higher
   P7-4 (USBV) - Body ground	Always	10 kΩ or higher
   P7-5 (VOT-) - Body ground	Always	10 kΩ or higher
   P7-6 (VOR-) - Body ground	Always	10 kΩ or higher
   P7-7 (VOR+) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   * a	Front view of wire harness connector (to DCM [Telematics Transceiver])
   * b	Front view of wire harness connector (to Multi-media Module Receiver Assembly)

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

(Refer to PROBLEM SYMPTOMS TABLE [09/2015 - 08/2017] )

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR