LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2017 >> IS 350 Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Access System (For Entry) - Diagnostic Codes & Symptom Tests (1 Of 2) >> Smart Access System With Push-Button Start (For Entry Function) >> All Door Entry Lock/Unlock Functions And Wireless Functions Do Not Operate [04/2013 - 09/2020] >> Caution / Notice / Hint
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Caution / Notice / Hint

NOTE:
  • The Smart Access System With Push-Button Start (For Entry Function) Uses The Lin Communication System And Can Communication System. Inspect The Communication Function By Following How To Proceed With Troubleshooting. Troubleshoot The Smart Access System With Push-Button Start (For Entry Function) After Confirming That The Communication Systems Are Functioning Properly.

    Refer To How To Proceed With Troubleshooting [04/2013 - 09/2022]

  • When Using The Techstream With The Engine Switch Off, Connect The Techstream To The Dlc3 And Turn A Courtesy Light Switch On And Off At Intervals Of 1.5 Seconds Or Less Until Communication Between The Techstream And The Vehicle Begins. Then Select The Vehicle Type Under Manual Mode And Enter The Following Menus: Body Electrical / Smart Access. While Using The Techstream, Periodically Turn A Courtesy Light Switch On And Off At Intervals Of 1.5 Seconds Or Less To Maintain Communication Between The Techstream And The Vehicle.
  • Check That There Are No Electrical Key Transmitter Sub-Assemblies In The Vehicle.
  • Before Performing The Inspection, Check That Dtc B1242 (Wireless Door Lock Control) Is Not Output.

    Refer To Dtc Check / Clear [04/2013 - ]

  • Inspect The Fuses For Circuits Related To This System Before Performing The Following Procedure.
  • Before Replacing The Certification Ecu (Smart Key Ecu Assembly) Or Main Body Ecu (Multiplex Network Body Ecu), Refer To Smart Access System With Push-Button Start (For Entry Function) Precaution.

    Refer To Precaution [04/2013 - 06/2014] , or refer to Precaution [06/2014 - 10/2016] , or refer to Precaution [10/2016 - 09/2020]

  • After Repair, Confirm That No Dtcs Are Output By Performing "Dtc Output Confirmation Operation".
  • When Replacing The Door Control And Tire Pressure Monitoring System Receiver Assembly, Read The Transmitter Ids (Tire Pressure Warning System) Stored In The Old Ecu Using The Techstream And Write Them Down Before Removal.

    Refer To Registration [04/2013 - 09/2020]

  • It Is Necessary To Perform Initialization (Refer To Initialization [04/2013 - 09/2020] ) After Registration (Refer To Registration [04/2013 - 09/2020] ) Of The Transmitter Ids Into The Door Control And Tire Pressure Monitoring System Receiver Assembly If The Door Control And Tire Pressure Monitoring System Receiver Assembly Has Been Replaced.
scientia non olet · About LEMON Manuals