ECU Power Source Circuit [10/2014 - 09/2017]: Procedure

1. Disconnect the driving support ECU assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Rear view of wire harness connector (to Driving Support ECU Assembly)

2. Measure the voltage and resistance according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   I19-30 (B) - Body ground	Engine switch on (IG)	10.5 to 16 V
   I19-30 (B) - Body ground	Engine switch off	Below 1 V

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I19-25 (GND) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2014 - 09/2017] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR