DTC C1ABB: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete [10/2014 - ]: Procedure

1. Change the blind spot monitor sensor LH to Test Mode using the Techstream.

   Body Electrical > Blind Spot Monitor Master > Utility 

   Tester Display
   BSM Master Beam Axis Inspection

   HINT: 

   Refer to Blind Spot Monitor Beam Axis Inspection.

   Refer to OPERATION CHECK [10/2014 - 09/2016] , or refer to OPERATION CHECK [09/2016 - 09/2017] , or refer to OPERATION CHECK [09/2017 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

END