DTC B1575: GVIF Disconnected (from EMV/MM Integrated Device to Multi Display) [10/2014 - 09/2017]: Procedure
- CLEAR DTC
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]
Body Electrical > Navigation System > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 2
- Clear the DTCs.
- CHECK DTC
- Recheck for DTCs and check if the same DTC is output again.
Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]
Body Electrical > Navigation System > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017]
Result:
NG
See step 3
- Recheck for DTCs and check if the same DTC is output again.
- CHECK HARNESS AND CONNECTOR (GVIF CABLE)
- Check that the digital signal lines between the multi-display assembly and radio receiver assembly are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.
OK
There are no installation problems.
Result
Proceed to OK NG
Result:
NG
REPLACE HARNESS AND CONNECTOR (GVIF CABLE)
Result:
OK
See step 4
- Check that the digital signal lines between the multi-display assembly and radio receiver assembly are not sharply bent or pinched, and that the connectors are properly connected and there are no other installation problems.
- REPLACE HARNESS AND CONNECTOR (GVIF CABLE)
Result:
NEXT
See step 5
- CLEAR DTC
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]
Body Electrical > Navigation System > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 6
- Clear the DTCs.
- CHECK DTC
- Recheck for DTCs and check if the same DTC is output again.
Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]
Body Electrical > Navigation System > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
END (GVIF CABLE IS DEFECTIVE)
Result:
NG
See step 7
- Recheck for DTCs and check if the same DTC is output again.
- REPLACE MULTI-DISPLAY ASSEMBLY
- Replace the multi-display assembly.
Refer to REMOVAL [10/2014 - 09/2017]
Result
Proceed to NEXT
Result:
NEXT
See step 8
- Replace the multi-display assembly.
- CLEAR DTC
- Clear the DTCs.
Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]
Body Electrical > Navigation System > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 9
- Clear the DTCs.
- CHECK DTC
- Recheck for DTCs and check if the same DTC is output again.
Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]
Body Electrical > Navigation System > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
OK
END (MULTI-DISPLAY ASSEMBLY IS DEFECTIVE)
Result:
NG
REPLACE RADIO RECEIVER ASSEMBLY. Refer to REMOVAL [10/2014 - 09/2017]
- Recheck for DTCs and check if the same DTC is output again.