How To Proceed With Troubleshooting [10/2014 - 09/2017]: Procedure

Result

Result: 

NEXT 

See step  2

1. Measure the battery voltage.

   Standard voltage

   11 to 14 V

   HINT: 

   • A simple method to determine whether the battery is discharged is to operate the horn.
   • If the voltage is below 11 V, recharge or replace the battery before proceeding.
2. Check the fuses and relays.
3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Check the vehicle type.

   Result

   Result	Proceed to
   w/ Rain Sensor	A
   w/o Rain Sensor	B

Result: 

B 

See step  5

Result: 

A 

See step  4

1. Use the Techstream to check if the LIN communication system is functioning normally.

   Refer to DTC CHECK / CLEAR [10/2014 - 09/2017]

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO LIN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - ] 

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [10/2014 - 09/2017] 

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

Result: 

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  6

1. Terminals of ECU

   Refer to TERMINALS OF ECU [10/2014 - 09/2017] 

2. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [10/2014 - 09/2017] 

3. Inspection
   1. Windshield wiper motor assembly

      Refer to INSPECTION [10/2014 - ]

   2. Rear wiper motor assembly

      Refer to INSPECTION [10/2014 - ]

   3. Windshield wiper switch assembly

      Refer to INSPECTION [10/2014 - ]

   4. Windshield washer motor and pump assembly

      Refer to INSPECTION [10/2014 - ]

   5. Level warning switch assembly

      Refer to INSPECTION [10/2014 - ]

   6. Map light assembly (w/ Rain Sensor)

      Refer to INSPECTION [10/2014 - ]

4. On-vehicle inspection
   1. Windshield wiper motor assembly

      Refer to ON-VEHICLE INSPECTION [10/2014 - ]

   2. Rear wiper motor assembly

      Refer to ON-VEHICLE INSPECTION [10/2014 - ]

   3. Windshield wiper switch assembly

      Refer to ON-VEHICLE INSPECTION [10/2014 - ]

   4. Rain sensor (w/ Rain Sensor)

      Refer to ON-VEHICLE INSPECTION [10/2014 - 09/2017]

   5. Headlight cleaner control relay (w/ Headlight Cleaner System, for Triple Beam Headlight)

      Refer to ON-VEHICLE INSPECTION [10/2014 - ]

   6. Headlight cleaner control relay (w/ Headlight Cleaner System, for Single Beam Headlight)

      Refer to ON-VEHICLE INSPECTION [10/2014 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END