Display Signal Circuit between Multi-display and Radio Receiver [10/2014 - 09/2017]: Procedure

1. Check if the GVIF cable connector between the radio receiver assembly and the multi-display assembly has any connection problems.
2. Check that the screen display is normal.

   OK

   Screen display is normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [10/2014 - 09/2017] 

Result: 

NG 

See step  2

1. Replace the harness and connector (GVIF cable).
2. Check that the screen display is normal.

   OK

   Screen display is normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (GVIF CABLE IS DEFECTIVE) 

Result: 

NG 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2014 - 09/2017]