Installation [09/2014 - 10/2015]: Procedure

INSTALL FRONT AXLE HUB SUB-ASSEMBLY
Refer to PROCEDURE - Step 1

HINT:
- If the front speed sensor rotor needs to be replaced, replace the front axle hub sub-assembly.
- The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor is malfunctioning, replace the front axle hub sub-assembly.
INSPECT FRONT AXLE HUB BEARING LOOSENESS
Refer to PROCEDURE - Step 4
INSPECT FRONT AXLE HUB RUNOUT
Refer to PROCEDURE - Step 5
INSTALL FRONT DISC
Refer to PROCEDURE - Step 1
INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
Refer to PROCEDURE - Step 7
INSTALL FRONT SKID CONTROL SENSOR WIRE
1. Connect the connector to install the front skid control sensor wire.
2. Engage the 2 clamps to the front No. 1 stabilizer bracket and vehicle body.
  NOTE:
  Do not twist the front skid control sensor wire when installing it.
3. Return the front fender liner to its original position.
4. Install the 2 sensor clamps to the front shock absorber assembly and vehicle body with the 2 bolts.
  Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf)
  
  NOTE:
  Do not twist the front skid control sensor wire when installing it.
5. Connect the connector to the front axle hub sub-assembly.
INSTALL FRONT FENDER LINER
1. Install the front fender liner with the screw.
INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 116
INSTALL FRONT WHEEL
Refer to PROCEDURE - Step 1
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [09/2014 - 10/2015]
CHECK FOR SPEED SENSOR SIGNAL
Refer to TEST MODE PROCEDURE [09/2014 - 11/2017]