LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2017 >> RC F >> Repair and Diagnosis >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Cruise Control System - Diagnostics - Introduction >> Cruise Control System >> DTC Check / Clear [09/2014 - 11/2017] >> DTC Check / Clear [09/2014 - 11/2017]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check / Clear [09/2014 - 11/2017]

  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
    5. Check the details of the DTC(s).

      Refer to DIAGNOSTIC TROUBLE CODE CHART [09/2014 - 11/2017] 

      Powertrain > Cruise Control > Trouble Codes 

  2. CLEAR DTC (Using the Techstream) 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
    5. Clear the DTCs.

      Powertrain > Cruise Control > Clear DTCs 

  3. CLEAR DTC (without using the Techstream) 
    1. Perform either of the following operations:
      NOTE:

      After turning engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Refer to PRECAUTION [09/2014 - 11/2017]

      1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.
      2. Remove the EFI-MAIN and ETCS fuses from the No. 2 engine room relay block and No. 2 junction block assembly located inside the engine compartment for more than 1 minute.
scientia non olet · About LEMON Manuals