Initialization [09/2015 - 08/2019]
NOTE:
- The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight ECU sub-assembly LH removal/installation are shown below.
Performed Work or System Condition Necessary Procedures Link Replacement of the headlight ECU sub-assembly LH Synchronize the vehicle information Refer to INITIALIZATION [09/2015 - 08/2019] Perform headlight ECU sub-assembly LH initialization Replacement of the rear height control sensor sub-assembly RH, removal and reinstallation of the rear height control sensor sub-assembly RH, replacement of the suspension, etc. have been performed. Perform headlight ECU sub-assembly LH initialization Battery terminal is disconnected and connected. Steering Sensor Zero Point Calibration Refer to INITIALIZATION [09/2015 - 08/2019] - If the steering sensor zero point calibration is not performed, the AFS (adaptive front-lighting system) and cornering lights may not operate correctly.
- A new headlight ECU sub-assembly LH cannot operate until the vehicle information is registered.
- After replacing the headlight ECU sub-assembly LH, it is necessary to perform vehicle information registration and initialization.
- Even if the headlight ECU sub-assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.