DTC C1AA9: Front Camera Module Beam Axis Not Adjusted [07/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
5. Check for DTCs. Refer to DTC CHECK / CLEAR [07/2015 - ]

Result:  NEXT

NEXT 

See step  2

1. Adjust the forward recognition camera. Refer to ADJUSTMENT [07/2015 - ]

Result:  NEXT

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
5. Clear the DTCs. Refer to DTC CHECK / CLEAR [07/2015 - ]
6. Make sure that the DTC detection conditions are met.

   HINT: 

   If the detection conditions are not met, the system cannot detect the malfunction.

7. Check for DTCs. Refer to DTC CHECK / CLEAR [07/2015 - ]

   Result

   Result	Proceed to
   DTC C1AA9 is output.	A
   DTC C1AA9 is not output.	B

8. Turn the power switch off.

Result:  A

A 

REPLACE FORWARD RECOGNITION CAMERA 

Refer to COMPONENTS [07/2015 - ]

Result:  B

B 

END