Caution / Notice / Hint
NOTE:
- When using the Techstream with the vehicle engine switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
- The smart access system with push-button start (for Start Function) uses the LIN communication system and the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Refer to HOW TO PROCEED WITH TROUBLESHOOTING (07/2015 -) ). Troubleshoot the smart access system with push-button start (for Start Function) after confirming that the communication systems are functioning properly.
- Before replacing the certification ECU (smart key ECU assembly), refer to smart access system with push-button start (for Start Function) Precaution (Refer to PRECAUTION (07/2015 -) ).
- After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
HINT:
RELATED DATA LIST AND ACTIVE TEST ITEMS
| DTC | Data List Item | Active Test Item |
|---|---|---|
| B2277 | - | - |
HINT:
Before proceeding with troubleshooting, check if there are any signs of water damage to the certification ECU (smart key ECU assembly). If there are any signs of water damage, replace the certification ECU (smart key ECU assembly) and take measures against the cause of the water damage.