Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [07/2015 - ]: Procedure
- READ VALUE USING TECHSTREAM (MASTER SWITCH)
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Master switch / Data List.
- Read the Data List according to the display on the Techstream.MASTER SWITCH
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver door power window auto switch signal / ON or OFF ON: Driver door power window auto switch being operated
OFF: Driver door power window auto switch not being operated- OK
On the Techstream screen, ON or OFF is displayed accordingly.
Result: NG
NG
REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(Refer to REMOVAL [07/2015 - ] )
Result: OK
OK
See step 2
- READ VALUE USING TECHSTREAM (D-DOOR MOTOR)
- Enter the following menus: Body Electrical / D-Door Motor / Data List.
- Read the Data List according to the display on the Techstream.D-DOOR MOTOR
Tester Display Measurement Item/Range Normal Condition Diagnostic Note D Door P/W Auto SW Driver door power window auto switch signal / ON or OFF ON: Driver door power window auto switch being operated
OFF: Driver door power window auto switch not being operated- OK
On the Techstream screen, ON or OFF is displayed accordingly.
Result: NG
NG
See step 5
Result: OK
OK
See step 3
- PERFORM INITIALIZATION (FOR DRIVER DOOR)
- Initialize the power window regulator motor assembly (for driver door) (Refer to INITIALIZATION [07/2015 - ] ).
Result: NEXT
NEXT
See step 4
- CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
- Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [07/2015 - ]
).
OK
Driver door auto up and down function is normal.
Result: OK
OK
END (PROBLEM DUE TO INITIALIZATION FAILURE)
Result: NG
NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR)
(Refer to REMOVAL [07/2015 - ] )
- Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [07/2015 - ]
).
- REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
- Replace the multiplex network master switch assembly (Refer to REMOVAL [07/2015 - ] ).
Result: NEXT
NEXT
See step 6
- CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
- Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [07/2015 - ]
).
OK
Driver door auto up and down function is normal.
Result: OK
OK
END (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WAS DEFECTIVE)
Result: NG
NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR)
(Refer to REMOVAL [07/2015 - ] )
- Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly is operated (Refer to OPERATION CHECK [07/2015 - ]
).