Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ECM removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Replacement of ECM | Vehicle Identification Number (VIN) registration | MIL comes on | Refer to REGISTRATION [10/2015 - ] |
| ECU communication ID registration (Immobiliser system) | Engine start function | Refer to REGISTRATION [10/2015 - ] | |
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Parking assist monitor system | Refer to INITIALIZATION [10/2015 - ] |
| Lane-keeping assist system | Refer to INITIALIZATION [10/2015 - ] | ||
| Pre-collision system | |||
| Reset power trunk lid | Power trunk lid system | Refer to INITIALIZATION [10/2015 - ] |
NOTE:
- Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.
Refer to REGISTRATION [10/2015 - ]
- Before replacing the ECM, refer to Registration.
Refer to PRECAUTION [10/2015 - ]