DTC B27A8: Open in Outside Luggage Compartment Electrical Key Antenna Circuit [08/2015 - 08/2019]: Procedure

1. Turn the engine switch off.
2. Check that the connectors are properly connected to the certification ECU and electrical key antenna (outside luggage).

   OK

   Connectors are properly connected.

Result: 

NG 

CONNECT CONNECTORS PROPERLY 

Result: 

OK 

See step  2

1. Disconnect the G27 certification ECU connector.
2. Disconnect the R19 electrical key antenna (outside luggage) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G27-19 (CLG8) - R19-1 (CLG5)	Always	Below 1 Ω
   G27-20 (CG8B) - R19-2 (CLGB)	Always	Below 1 Ω
   G27-19 (CLG8) or R19-1 (CLG5) - Body ground	Always	10 kΩ or higher
   G27-20 (CG8B) or R19-2 (CLGB) - Body ground	Always	10 kΩ or higher

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Remove the electrical key antenna (outside luggage) (Refer to REMOVAL [08/2015 - 08/2019] ).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   1 (CLG5) - 2 (CLGB)	Always	Below 1 Ω

Result: 

NG 

REPLACE ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE) 

(Refer to REMOVAL [08/2015 - 08/2019] )

Result: 

OK 

See step  4

1. Temporarily replace the certification ECU with a new one (Refer to REMOVAL [08/2015 - 08/2019] ).

Result: 

NEXT 

See step  5

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).

Result: 

NEXT 

See step  6

1. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).

   OK

   DTC B27A8 is not output.

Result: 

OK 

END (CERTIFICATION ECU IS DEFECTIVE) 

Result: 

NG 

REPLACE ELECTRICAL KEY ANTENNA (OUTSIDE LUGGAGE) 

(Refer to REMOVAL [08/2015 - 08/2019] )