Navigation Receiver Assembly Power Source Circuit [10/2015 - 08/2019]: Procedure

1. Disconnect the J50 radio receiver assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J50-12 (GND1) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   J50-17 (+B1) - J50-12 (GND1)	Power switch off	11 to 14 V
   J50-16 (ACC1) - J50-12 (GND1)	Power switch on (ACC)	11 to 14 V
   J50-15 (IG) - J50-12 (GND1)	Power switch on (IG)	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2015 - 03/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [03/2018 - 08/2019] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR