LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2020 >> LC 500h >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Can Communication System - Circuit Tests (2 Of 6) >> Can Communication System >> Restraints Occupant Classification System Module Communication Stop Mode [05/2023 - ] >> Caution / Notice / Hint
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Caution / Notice / Hint

WARNING:

When performing the confirmation driving pattern, obey all speed limits and traffic laws.

NOTE:
  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [05/2023 - ]

  • Inspect the fuses for circuits related to this system before performing the following procedure.
  • Before measuring the resistance of the CAN bus, turn the power switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) auxiliary battery terminal and leave the vehicle for 10 minutes or more before measuring the resistance.
  • After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]

  • When disconnecting and reconnecting the auxiliary battery.

    HINT: 

    When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

    Refer to AUTOMATIC LEARNING CHART [05/2023 - ]

  • Some parts must be initialized and set when replacing or removing and installing parts.

    Refer to WORK PROCEDURE [05/2023 - ]

  • After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.

    DTC check procedure: Turn the power switch on (IG) and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.

  • After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed as normal.

    Refer to DIAGNOSIS SYSTEM [05/2023 - ]

HINT: 

scientia non olet · About LEMON Manuals