Data List / Active Test [09/2014 - 11/2017]
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Telematics / Data List.
- According to the display on the Techstream, read the "Data List".
Body Electrical > Telematics > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note Emergency Switch Manual (SOS) switch OFF or ON OFF: Manual (SOS) switch not pressed
ON: Manual (SOS) switch pressed- MIN Phone number to be assigned to telematics (for communication carrier) Display the phone number for communication carrier Display the phone number for communication carrier - MDN Phone number to be assigned to telematics (for customer) Display the phone number for customer Display the phone number for customer - MEID Only MEID (cellular module ID) is displayed on the Techstream. Serial number to be assigned to cellular module in telematics. Display the cellular module ID number Display the cellular module ID number - Number of Trouble Codes The number of the DTC which is currently output Min.: 0 or Max.: 255 Number of DTCs will be displayed -