DTC B2450: Height Sensor Initialization Incomplete [08/2019 - ]: Procedure

1. Perform initialization of the No. 1 headlight ECU sub-assembly LH.

   Refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / AFS / Trouble Codes.
5. Clear the DTCs.

   Body Electrical > AFS > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / AFS / Trouble Codes.
5. Check for DTCs.

   Body Electrical > AFS > Trouble Codes 

   OK

   DTC B2450 is not output.

   HINT: 

   If the No. 1 headlight ECU sub-assembly LH stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the No. 1 headlight ECU sub-assembly LH.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (INITIALIZATION WAS NOT COMPLETED) 

Result: 

NG 

REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to  REMOVAL [08/2019 - ]