DTC C1AB7: Blind Spot Monitor Slave Module [08/2019 - ]: Procedure

1. Turn the engine switch off.
2. Turn the engine switch on (IG).
3. Recheck for DTCs and check if the same DTC is output again.

   Body Electrical > Blind Spot Monitor Slave > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR RH. Refer to  REMOVAL [08/2019 - ]