LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2023 >> LX 600 Base >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Access System (For Start) - Diagnostic Codes >> SMART ACCESS SYSTEM WITH PUSH-BUTTON START (for Start Function) >> DTC B2782-11: Power Source Control System Circuit Short to Ground [12/2021 - ] >> Description
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC B2782-11: Power Source Control System Circuit Short to Ground [12/2021 - ]: Description

The certification ECU (smart key ECU assembly) has a power source mode switching function.

This DTC is stored when the IGE input (the steering lock motor activation permission signal) sent directly from the certification ECU (smart key ECU assembly) to the steering lock ECU (steering lock actuator with ECU assembly) is determined to be abnormal.

HINT: 

The steering lock ECU (steering lock actuator with ECU assembly) is not connected to the CAN communication system. However, the steering lock ECU (steering lock actuator with ECU assembly) is connected to the certification ECU (smart key ECU assembly) via LIN communication and communicates with other components via CAN communication through the certification ECU (smart key ECU assembly).

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Priority Note
B2782-11 Power Source Control System Circuit Short to Ground Either of the following conditions is met (1-trip detection logic (Only output while a malfunction is present and the ignition switch is ON.)):
  • The steering lock motor activation command circuit has a short circuit.
  • The steering lock motor activation command circuit has an open circuit.

HINT: 
If the power supply signal from the LIN communication line does not match the power supply signal from the direct line, the system is determined to be malfunctioning.
  • Steering lock ECU (steering lock actuator with ECU assembly)
  • Certification ECU (smart key ECU assembly)
  • Wire harness or connector
 Smart Access B DTC Output Confirmation Operation: 
  1. Perform a steering lock/unlock operation. (The steering locks when a door is opened with the shift lever in P and the ignition switch off. The steering unlocks when the ignition switch is turned to ACC or ON while carrying the key.)
VEHICLE CONDITION AND FAIL-SAFE FUNCTION WHEN MALFUNCTION DETECTED

Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
The steering cannot be locked or unlocked. For this reason, the engine cannot be started. Prohibits the engine from being started (the engine does not start).
RELATED DATA LIST AND ACTIVE TEST ITEMS

DTC No. Data List and Active Test
B2782-11 -
scientia non olet · About LEMON Manuals